STEP 1 : Unfold the deflated Mercury Boat
Clear a flat space (making sure it is clean and free of sharp objects) and unfold your Mercury boat. Remove the hull from its box and take it out of the boat bag. Unroll the hull so it laid out flat.
STEP 2 : Inflate slightly
Push and twist all valves one quarter to the closed position. The Mercury Inflatable Boats can be inflated either with a hand pump or with electric pump. The electric pump can inflate the boats to a moderate pressure and save a lot of time, but boat will need to be finished off with a hand pump. Inflate all hull chambers to approximately 30% full in order to make floorboard insertion easier.
STEP 3 : Place the hard floor floorboards together inside the boat
Each floorboard is labeled with the number. Florrboard number 1 will be the font floorboard and florboard number 4 (or florboard number 3 for inflatables DYL230/DYF230, DYL270/DYF270 ) will be placed next to the transom. Place floorboard # 1 at at bow part. Make sure you get first floorboard as far forward as possible ,right in the join between the bottom of the boat and pantoon. Make sure that keel valve is located at the center of #1 boards hole
Place floorboard number 4 next to the transom
Florboard number 2 and number 3 should be placed angular to each other. Push floorboard downwards to join these floorboards in flat position.
STEP 4 : Attach side joiners
Attach side joiners to the floor along the tubes to create a solid floor system
STEP 5 : Attach seats
Attach wooden seat properly by placing plastic adges with seat with the seat holders located on the sides of the boat
STEP 6 : Inflate the boat
Start inflating the front air chamber, followed by the two side of air chambers . And finally inflate the keel in the middle .Place cap on the valve an d twist tight. Join the oars into piece an d properly attach them on the side oar lock. Then screw cap tight to the fasten
To Buy Mercury Inflatable Boat in India Contact Us @ 022 6677 6659
|
